Aviron Spectrasfalt
Microdeck Color Premix
Product description
Aviron Spectrasfalt Microdeck Color
premix is a mortar comprising two components. After mixing
these components, an
easily processable, colored emulsion-asphalt concrete [Slurry Seal] is
formed which can be
applied in a coat of at least 3-mm thick
Composition
Component A is composed of a
mixture of selected aggregate,
that approximates the final color as closely as possible,
fibers, pigment and a few additives that influence the workability.
Component
B is the standard Microdeck Color emulsion
that can be used for the mechanical
application of a colored Slurry
Seal.
Component C
is Portland Cement
Characteristics Drying
time 1-3 hours at a temperature of
Wear-
resistance WTAT [ISSA 100] <2%[max. 10%]
Adhesive strength concrete >0,8 N/mm2
asphalt >0,4
N/mm2
Application As
wear-resistant, thin coating in a variety of colours
on asphalt and concrete. To be used in
building houses and roads as a support or to indicate in colors when
changes are made in road sections,
parking lots, boulevards, shopping streets,
bicycle lanes etc. In situations where it is not possible to apply the Slurry Seal
mechanically,
then the premix mortar can be used effectively
Processing Component A and C are added to a cement /
concrete mixer. Next, add an adjusted amount
of emulsion (component B) to the mortar. You may then add water
if necessary to achieve the correct processability.
Pour out the mortar and apply evenly with a rubber squeegee in a thin layer of
approximately 3-mm. If you wish to make special patterns or use small strokes, you should first tape off the
surrounding area. The processing time under
normal surrounding temperature is 5 to 10 minutes. In conditions of hot weather an amount of delaying agent may be
added to adjust the processing time.
If the ground is very dry, it is advisable to dampen it before beginning.
During
processing the average daily temperature should be not less than
Comments The mortar may only be applied in
thin layers in dry weather conditions. The surface layer will be ready between
3 and 5 hours following application. Masking tape should be removed as quickly
as possible, as it is very difficult to
remove once it has been driven over.
Use With
a coat thickness of approx. 3-mm: approx. 5 kg/m2.
Color Red (on request Green, Yellow and Blue)
Packaging Component A :
Component
B :
The
Information submitted in this publication Is based on our current knowledge and
experience, In view of the many factors that may affect processing and
application, these data do not relieve processors of the responsibility or
carrying out their own tests and experiments; neither do they imply any legally
Binding assurance of certain properties or of
suitability for a specific purpose. It is the responsibility of those to whom
we supply our products to ensure that any proprietary rights and existing laws and legislation are observed